1. Create a sketch of the area you wish
to install your fence (use sample above as a guide).
2. Establish all gate(s) and/or transition location
3. Determine number of sections; keep in mind that if a required
section is less than 6', this will require the
section to be trimmed. Example: 20' of fence will require 4
sections (4 sections x 6' = 24', 4' must be trimmed to accommodate
installation).
4. Determine the number of posts. Note - all gates must be installed
with left and right gate posts only.
5. Enhance your design as you like by adding accessories such
as scrolls, finials, ball caps, etc.
Before
Installation
Consult your building department
for local code requirements. Check with utility companies
to locate
underground pipes, lines, cables, etc.
Basic
Installation Instructions*
1. Dig post hole.
2. Insert appropriate post into hole (Figure 1).
3. Slide the fence-section rails into the pre-punched post
(Figure 2).
4. Fill post-hole with concrete.
5. Secure with enclosed screws.
6. Plumb and level the posts and pickets while the concrete
is setting. Brace the post as necessary while concrete sets.
7. Hang gate(s) to appropriate gate post(s).
8. Attach any gate or post hardware and/or fence accessories.
*Please reference product
boxes for detailed installation instructions
`